Evs MulticamLSM Version 8.03 - Dec 2006 User's Ma Manual de usuario descargar pdf (Pagina 56)

EVS MULTICAM - User’s ManualVersion 8.03

EVS Broadcast Equipment SA – Dec 2006

To return to the operational menu, press the MENU key from the Remote

controller.

Rst Cam Local Sync Prv 2nd CTRL

Cam A Cam B Cam C Cam D

CAM A/ B /C /D: selects the camera on the PGM output if PRV CTL is

OFF and on PRV output if PRV CTL is ON.

Note: In 5CAM configuration (5 record and 1 play) or when loading a clip where CAM E or

F exists, the operational menu will display :

Rst Cam Local Sync Prv 2nd CTRL

Cam A Cam B Cam C --->

By pressing the D key (--->), the operator has access to the D, E and F cameras.

The operation menu becomes :

Rst Cam Local Sync Prv 2nd CTRL

Cam D Cam E Cam F <---

Press the D key (<---) to return to CAM A, B, C selection.

Rst Cam:

This function restores the position of cameras on the active channels:

CAM A on PGM1, CAM B on PRV.

Note: When a clip/playlist is loaded on a channel, switching back to Live mode will recall

the record train, which was last used on that output. This avoids too frequent uses of

the RST CAM function.

Local: connects clips and trains to the local LSM. This function is

highlighted when both clips and records trains are connected to the local

LSM and appears only on Master/Server LSM’s when they are connected

to the SDTI network.

Sync Prv:

This option allows you to synchronize the PRV with the PGM output at the

same Timecode and same speed. This function is not available with

remote record trains.

2nd CTRL: allows the operator to swap the control of one or several play

channels between the EVS remote and a third-party controller using the

Sony BVW75 or XtenDD35 protocol. Both controllers receive the status

of the channel(s) all the time, but only one controller at a time is able to

actually control a channel. The secondary controllers are defined in

section 7 of the remote Setup Menu.

Press this function to enter the 2nd CTRL menu, select the channels that

you want to pass to the secondary controller by pressing the

corresponding A or B key, then press D (DONE) to validate your

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 155 156

Sin comentarios

Evs MulticamLSM Version 8.03 - Dec 2006 User's Ma Manual de usuario Pagina 56