Evs XEDIO CleanEdit Version 4.1 - December 2011 User M Manual de usuario descargar pdf (Pagina 191)

Xedio Suite Version 4.1 – User’s Manual – CleanEdit

EVS Broadcast Equipment – December 2011

Issue 4.1.B

177

10.2.5 ADDING AUDIO TRANSITION EFFECTS ON ELEMENTS OF THE

SAME TRACK

INTRODUCTION

You want to add audio transition effects to:

• a selected element OR

• contiguous elements

on a given audio track.

In this case, you will use the (Left/Right) Audio Transition commands in the

contextual menu available on audio elements in the timeline.

For more information on the various types of transition effects, refer to the section

10.2.4 ‘Possible Audio Transition Effects’, on page 176.

The following audio transition effects are available: Cut, Fade OUT, Fade IN,

Cross Fade.

HOW TO APPLY AUDIO TRANSITION EFFECTS ON ELEMENTS

ON THE

SAME TRACK

To apply audio transition effects to one element or contiguous audio elements of

the same track, proceed as follows:

1. If you want to define a transition effect on several contiguous transitions, set a

mark IN and mark OUT points to cover the clips on which the effects should be

applied.

Otherwise, the transition effect will be defined on the nearest transition to the

position of the mouse cursor.

2. Right-click the mouse on the track where you want to define the transition

effect either:

o near the clip transition OR

o between the define mark IN and mark OUT

The contextual menu is displayed:

1 2 ... 186 187 188 189 190 191 192 193 194 195 196 ... 245 246

Sin comentarios

Evs XEDIO CleanEdit Version 4.1 - December 2011 User M Manual de usuario Pagina 191