Evs XEDIO CleanEdit Version 4.2 - June 2012 User Manua Manual de usuario Pagina 150

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 252
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 149
Xedio Suite Version 4.2User Manual CleanEdit
EVS Broadcast Equipment June 2012
136
RESULT
Once the speed has been changed, the length of the video element is adapted
accordingly and will show a square pattern to indicate the clip speed has been
adjusted.
The modified speed is displayed next to the element name:
In Overwrite mode, this may remove material after the clip.
When the clip speed exceeds 100%, you need to render the clip, using the
button. For more information on fast motion clips, refer to the section 7.10.3
Rendering Fast Motion Clips’, on page 136.
7.10.3 RENDERING FAST MOTION CLIPS
You should render fast motion clips: The Rendering button is enabled
above the timeline as soon as a fast motion clip is detected in the timeline.
When you check an edit with fast motion clips that have not yet been rendered,
the following message will be displayed:
Selecting Yes will render the fast motion clips immediately, selecting No will leave
them as such (not rendered). The transcoding codec used for the rendering of a
fast motion clip is set in Xedio Manager.
The name of the rendered file follows the pattern below:
FM_IdMediaOrigin_tcInMedia_tcOutMedia_speed_GUID_[lr/
hr].[ext] where:
IdMediaOrigin = ID of the original media
tcInMedia = TC IN (in HHMMSSFF)
tcOutMedia = TC OUT (in HHMMSSFF)
speed = Speed (in %)
GUID = Unique identifier (GUID)
lr/hr = Resolution: either lr (lo-res) or hr (hi-res)
.ext = File format depending on the codec type
Vista de pagina 149
1 2 ... 145 146 147 148 149 150 151 152 153 154 155 ... 251 252

Comentarios a estos manuales

Sin comentarios