Evs XSnano Version 11.02 - July 2012 Configuration Man Manual de usuario descargar pdf (Pagina 165)

Push Target 1 / 2

Description Specifies to which machine(s) on the network the clips must

automatically be sent when the operator uses the PUSH

function on the LSM Remote Panel.

The machines defined in this setting are also used as default

target for clip copies.

The users can define two default targets: Target 1/ Target 2.

The clips will be pushed in sequential order.

Values A list of values will be displayed depending on the value

assigned to the Target setting:

• --------:

When no target is defined in these parameters, the user will

be able to define the requested target when (s)he calls the

PUSH function.

• <GigE server name and IP Address> are listed and can

be assigned for targets belonging on the GigE network.

Default Values -------- (No target machine specified)

Push Mode

Description Specifies how the clips should be sent using the PUSH

function, that is to say with or without the original guardbands.

Values The following values are possible:

• Short:

The clips are sent from the Short IN to the Short OUT

points, to which the guardbands of the destination machine

are added.

• Long:

The clips are sent from the Protect IN to the Protect OUT.

Default Values Short

Push Receive Page

Description Specifies the page of your machine where clips sent to you by

other network operators using the PUSH function must be

stored.

See section "Navigating and Editing in the Multicam

Configuration Window" on page 46 for more information on

how to enable pages

Values Page 1 to 10 (=0). Several pages can be selected.

Default Values (Page) 5

CONFIGURATION MANUAL XSnano Server 11.02

3. Multicam Configuration 157

1 2 ... 160 161 162 163 164 165 166 167 168 169 170 ... 173 174

Sin comentarios

Evs XSnano Version 11.02 - July 2012 Configuration Man Manual de usuario Pagina 165