EVS XT2+ Manual de usuario descargar pdf (Pagina 55)

XT2+ Series DISK RECORDER - Version 10.05 - Hardware Technical Reference Manual

Issue

10.05.A

EVS Broadcast Equipment SA – July 2011

BLOCK DIAGRAM

JUMPERS ON THE COHX BASE MODULE

ST1, ST2: These 2 jumpers must be installed on the last COHX board of the

server (i.e. on COHX #1, 2 or 3 if there are respectively 1, 2 or 3

COHX board installed in the server)

ST3 (SPARE): « parking » for jumpers for ST1 and ST2 when these are not used

ST4 (only on

COHX with

genlock) :

It must be set to HiZ (or not installed).

Note that the Genlock Loop connector on the back panel of the

XT2+ server must always

be terminated with a 75 Ohm load if it

is not used.

ST5 : It defines the position of the board inside the server.

It must be set to « 1 » for a COHX with genlock, and to « 2 » or

« 3

» for a COHX board without genlock, depending on its

position in the server.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 86 87

Sin comentarios

EVS XT2+ Manual de usuario Pagina 55