EVS XT2+ Manual de usuario descargar pdf (Pagina 61)

XT2+ Series DISK RECORDER - Version 10.05 - Hardware Technical Reference Manual

Issue

10.05.A

EVS Broadcast Equipment SA – July 2011

BLOCK DIAGRAM

JUMPERS ON THE COHX BASE OF A V3X BOARD

ST1, ST2: These 2 jumpers must be installed on the last V3X board of the

server (i.e. on V3X #1, 2 or 3 if there are respectively 1, 2 or 3

V3X board installed in the server)

ST3 (SPARE): «parking» for jumpers for ST1 and ST2 when these are not used

ST4 (only on

V3X with

genlock):

It must be set to HiZ (or not installed).

Note that the Genlock Loop connector on the back panel of the

XT2+ server must always

be terminated with a 75 Ohm load if it

is not used.

ST5: It defines the position of the board inside the server. It must be

set to « 1 » for a V3X with genlock, and to « 2 » or « 3 » for a

V3X board without genlock, depending on its position in the

server.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 86 87

Sin comentarios

EVS XT2+ Manual de usuario Pagina 61