Evs IPDirector Version 5.8 - July 2010 Part 6 User Manual de usuario Pagina 120

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 178
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 119
IPDirector Version 5.8
User Manual
Part 6: Playout
Playlist Panel
EVS Broadcast Equipment – July 2010
Issue 5.8.B
109
END-CUE MECHANISM
When the END CUE mode is activated, the GPI is sent every time the playlist
stops, which means:
at the end of the playlist, except if the loop mode is activated and the start
mode option of the first element is set to Automatically.
every time a still mode option (Stop on Last, Stop on Last, Wait, Jump on
First or Stop on First) is set on an element.
Refer to section ‘Define Still/Start Mode Window’ on page 79 for more information
o
n these options.
End-Cue Characteristics
The END CUE duration is independent of the speed of the playlist. This means
that the GPI will be sent a period of time, corresponding to the END CUE
duration, before the playlist stops whatever the speed of the element may be.
The GPI is not necessarily sent during the playout of the element where the
playlist will stops as the END CUE duration can be greater than the element
duration.
The END CUE GPI is not sent if the END CUE duration is greater than the
remaining time until next break.
The END CUE duration as well as the END CUE GPI can be modified at any
time, should the END CUE mode be activated or not.
The END CUE mode is activated for a channel and not for a specific playlist.
The END CUE GPI and duration can be different for each channel.
The END CUE GPI is only sent in transmission mode, when the playlist is being
played out, not in Edit mode.
The END CUE mode is automatically turned off when the Multicam starts as
there is no reason to keep a mode from a previous use of an EVS server.
1.7.14 WORKING WITH POST-ROLL
PURPOSE
The Post-Roll is the ability to play an element a few seconds after its defined OUT
point, as far as there is enough A/V material in the guardband.
The purpose of using Post-Roll is:
to provide a countdown until the OUT point of the playlist element through the
Remaining Time until Next Transition value to allow the operator to know
when to switch to another device, and
to continue the playout after the OUT point in order not to freeze before the
operator performs the transition from the playlist.
Vista de pagina 119
1 2 ... 115 116 117 118 119 120 121 122 123 124 125 ... 177 178

Comentarios a estos manuales

Sin comentarios