Evs MulticamLSM Version 10.04 - January 2011 Configura Manual de usuario Pagina 25

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 98
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 24
EVS Multicam Version 10.04 – Configuration Manual
EVS Broadcast Equipment SA January 2011
Issue 10.4.A
17
UserBits Yes/No flag to specify if the user bits have to be inserted in the
output. The default value is ‘Yes’.
HANC VITC
Field to specify if embedded timecode has to be inserted in the
output. The value specified has to be the same as for the HANC
LTC field.
The possible values are:
No No new timecode inserted in the output.
In (default) Same timecode as in the input inserted in
the output.
LTC
Timecode from the LTC table inserted in
the output.
USER User-
defined timecode inserted in the
output.
SD OUT
D-VITC Field to specify if
embedded timecode has to be inserted in the
output. The possible values are:
No No new timecode inserted in the output.
In (default) Same timecode as in the input inserted in
the output.
LTC
Timecode from the LTC table inserted in
the output.
USER User-
defined timecode inserted in the
output.
Lines Lines on which the specified timecode must be written on the loop
of the input.
By default, these are lines 14-16 in NTSC and 19-21 in PAL.
UserBits Yes/No flag to specify if the user bits have to be inserted in the
output. The default value is ‘Yes’.
Clean VBI
Field in which the use specifies whether the VBI needs to be
cleaned on the output. The possible values are:
No The VBI is not cleaned in the output.
Always The VBI is always cleaned in the output.
If not OK
The VBI is cleaned in the output if it is not
correct (play var mode, vertical split
screen, etc.)
Vista de pagina 24
1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 97 98

Comentarios a estos manuales

Sin comentarios