Evs XT2 Version 11.02 - July 2013 Configuration Manual Manual de usuario Pagina 74

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 220
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 73
3.2.5. General Principles on 3D Configurations
Introduction
The 3D and 1080p configurations can be used on an XT2 server, using the following
connection interfaces:
Dual Link interface, that is to say two connections (on a record or play channel) seen
by the EVS server as one logical channel.
Connections on the Rear Panel with COHX Boards
You can only use the primary link of a codec module on a COHX board. As each
3D/1080p channel consists of two inputs, each channel requires using two codec
modules:
The first input is connected to the IN1 of a codec board.
The second input is connected to the IN2 of the next codec board.
The same principle applies to the playout channels.
3.2.6. 3D/1080p Standard Configurations
XT2 4U Servers
Available Configurations
The tables below show the available 3D and 1080p configurations with standard cameras
on a XT2 4U server. They show the link assignment at the level of the codec module of a
COHX board.
#REC #PLAY
IN4/OUT1 IN3/OUT2 IN2/OUT3 IN1/OUT4
Prim.
Link
Sec.
Link
Prim.
Link
Sec.
Link
Prim.
Link
Sec.
Link
Prim.
Link
Sec.
Link
1 0 REC1B REC1A
2 0 REC2B REC2A REC1B REC1A
0 1 PLAY1A PLAY1B
1 1 PLAY1A PLAY1B REC1B REC1A
0 2 PLAY1A PLAY1B PLAY2A PLAY2B
66 3. Multicam Configuration
EVS Broadcast Equipment S.A. Issue 11.02.A July 2013
Vista de pagina 73
1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 219 220

Comentarios a estos manuales

Sin comentarios