
XTnano – Version 10.03 – Configuration Manual
EVS Broadcast Equipment SA – July 2010
Issue
10.03.D
39
]
nu
Clips (PUSH) p.3.3
[F1] Target : Gigabit
[F2] Target 1 : Yellow 255.255.255.255
[F3] Target 2 : Brown #04
[F4] Mode : Short
[F5 Receive Pg : 1 2 3 4 5 6 7 8 9 0
[Me
]Quit [Ctr+F]Dft [F9]PgUp [F0]PgDn
3.9.5 TAR
si
lt Target 1 and Target 2 in the settings, or
• a target for a specific push action if no default target has been configured.
ork is available on XTnano servers, the value for this
via the GigE network
3.9.6
Possible values: GigE server name and IP Address
Default: -------- #--
arameter
automatically be operator uses the PUSH function on the EVS
nel.
The users can define two default targets: (F2): Target 1, (F3): Target 2. The clips
If no target is defined in these parameters, the user will be able to define the
3.9.7 MODE
Possible values: Short / Long
his parameter specifies how the clips should be sent using the PUSH function:
• Short: The clips are sent from the Short IN to the Short OUT points, to which
the guardbands of the destination machine are added.
• Long: The clips are sent from the Protect IN to the Protect OUT.
GET
Pos ble value: Gigabit
This parameter specifies which EVS servers will be listed as possible targets for
push actions when the user selects:
• the defau
Since only the GigE netw
setting is forced to ‘Gigabit’, and only the servers reachable
are listed with their GigE server name, and IP Address.
TARGET 1 & 2
This p specifies which machine(s) on the network clips must
sent to when the
Remote Pa
will be pushed in sequential order.
requested target when (s)he calls the PUSH function.
T
Comentarios a estos manuales