Evs XTnano Version 10.03 - July 2010 Operation Manual Manual de usuario descargar pdf (Pagina 44)

XTnano

–

Version 10.03

–

Operating Manual

EVS Broadcast Equipment SA – July 2010

Issue

10.03.D

SETTINGS ON COPY/MOVE CLIPS

When you copy/move a clip, two settings are available to specify how the clip

should be copied or moved:

Clip Mode/Cam Mode

Pressing the D key in the Copy/Move LCD window allows the user to select a value

for this setting:

• CLIP mode: all camera angles of the clips will be copied/moved.

• CAM mode: only the camera angles of the clip loaded on the controlled

channels will be copied/moved.

Default Settings

The default settings for the COPY/MOVE menu are: COPY and CLIP. If the

operator changes these settings, the new settings will be re-used the next time

this menu is called. The default settings will be automatically restored when

starting a new Multicam session.

HOW TO COPY OR MOVE A CLIP

It is possible to copy or move a clip on the same server. Growing clips can also be

copied and moved.

To copy or move a clip from the Remote Panel, proceed as follows:

1. Select the original clip.

2. Select an empty location on the same EVS server.

3. A new menu appears on the LCD display of the Remote Panel, with the

corresponding message on the OSD of the output monitors:

4. Select the COPY or MOVE function by pressing the A or B key.

The corresponding function will be highlighted on the LCD and the message

on the OSD will be updated accordingly.

5. Select the CLIP or CAM mode with the D key.

See Section “Settings on Copy/Move Clips” below.

Press ENTER to confirm or MENU to cancel.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 99 100

Sin comentarios

Evs XTnano Version 10.03 - July 2010 Operation Manual Manual de usuario Pagina 44