
EVS Multicam
Version 10.03
Configuration Manual
EVS Broadcast Equipment SA – July 2010
Issue 10.3.C
3
2. Setup in Multicam
2.1 INTRODUCTION
2.1.1 OVERVIEW
When you work in Spotbox mode, the ‘Setup Configuration’ module available in the
Multicam application, using the SHIFT-F2 keyboard combination, allows you to
configure the Multicam software and define server settings in relation to
timecodes, protocol communication, etc.
The other Multicam modules are discussed in the following manuals:
• Monitoring modules in the XT Tech Ref Software manual
• Multicam application in the User manual
This module contains several pages, i.e. windows, which are described in details
in this section:
Setup page and section
name
Content
Page 1
See Section 2.2 ‘
General Settings (Page 1)’,
on page 5.
I
t includes several general settings on the
timecodes, the OSD, the VGA, the network, the
clip management, the record trains, the channel
names, the RS422 protocols.
Page 2
See Section 2.3 ‘VITC/ANC
T
imecode Management (Page
2)’, on page 14.
It in
cludes detailed settings on the insertion of
VITC or ANC timecodes, channel by channel.
Page 3
See section 2.4 ‘SDTI
N
etwork Priorities (Page 3)’,
on page 18 and 2.5 ‘SMPTE
33
4M Packets Management
(Page 3)’, on page 18.
It
includes settings on:
• the priorities on the SDTI network
• the SMPTE 334M packet management
Page 4
See section 2.6 ‘GPI Settings
(P
age 4), on page 21.
It in
cludes the settings on the GPIs IN and OUT
Page 5
See section 2.7 ‘RS422
Protocol Settings (Page 5)’,
It includes settings on the VarID used with the
VDCP protocol.
Comentarios a estos manuales