Evs XTnano Version 11.01 - November 2012 Configuration Manual de usuario descargar pdf (Pagina 171)

Push Target 1 / 2

Description Specifies to which machine(s) on the network the clips must

automatically be sent when the operator uses the PUSH

function on the LSM Remote Panel.

The machines defined in this setting are also used as default

target for clip copies.

The users can define two default targets: Target 1/ Target 2.

The clips will be pushed in sequential order.

Values A list of values will be displayed depending on the value

assigned to the Target setting:

• --------:

When no target is defined in these parameters, the user

will be able to define the requested target when (s)he calls

the PUSH function.

• <GigE server name and IP Address> are listed and can

be assigned for targets belonging on the GigE network.

Default Values -------- (No target machine specified)

Push Mode

Description Specifies how the clips should be sent using the PUSH

function, that is to say with or without the original guardbands.

Values The following values are possible:

• Short:

The clips are sent from the Short IN to the Short OUT

points, to which the guardbands of the destination machine

are added.

• Long:

The clips are sent from the Protect IN to the Protect OUT.

Default Values Short

Push Receive Page

Description Specifies the page of your machine where clips sent to you by

other network operators using the PUSH function must be

stored.

See section "Navigating and Editing in the Multicam

Configuration Window" on page 47 for more information on

how to enable pages

Values Page 1 to 10 (=0). Several pages can be selected.

Default Values (Page) 5

161 3. Multicam Configuration

EVS Broadcast Equipment S.A. - November 2012 Issue 11.01.A

1 2 ... 166 167 168 169 170 171 172 173 174 175 176 ... 181 182

Sin comentarios

Evs XTnano Version 11.01 - November 2012 Configuration Manual de usuario Pagina 171