
EVS Multicam - User Manual
EVS Broadcast Equipment SA – March 2008
Version 9.00
9
3. Main Menu
After the boot sequence of the Multicam system, the LCD screen of the
Remote Control panel will display the Main menu:
Note
If 2 channels are available for the 1
st
Remote, the B key will
display 2 PGM. If 3 channels are available, the B key will display 3
PGM.
The Main menu has special function key operations as shown above, as well
as the “soft” keys options to enter 1PGM, 1PGM+PRV, 2PGM, or 3PGM
modes (if available) and to enter the Setup menu to configure your remote
controller or to add special functions to your application.
HOW TO RETURN TO THE MAIN MENU
From any section of the application, except Playlist mode, press SHIFT +
MENU on the first Remote Control panel to return to the Main menu.
FUNCTION KEYS IN THE MAIN MENU
Select the corresponding Function key (F_ key), and then press ENTER to
validate the selection.
Function Key Use
F1 to F4
If desired, the Multicam system can be run using 1, 2,
3 or 4 EVS Remote panels. Depending on the number
of play channels available in the current configuration,
1-, 2-, 3- or 4- Remote modes will be available from
the Main menu.
F1: 1 Remote
One Remote panel is used in the configuration
F2: 2 Remotes
Two Remote panels are used in the configuration.
If 4 play channels are available, when selecting the 2
Remotes mode, the operator can chose between 2
2Rec 4Play XT Multi-Cam Ver:09.00.xx
F1: 1 Remote F6: Exit
F2: 2 Remotes F7: Clear all clips
F3: 3 Remotes F8: Stop Record
F4: 4 Remotes F9: Fill Playlist
F5: Char. On/Off F0: Save Clips+Plist
Split Paint Target Setup
1PGM+PRV 3 PGM
Comentarios a estos manuales