
Audio Monitoring: Mon #1 - Mon #4
Description Specifies the source of the audio signal that will be sent to
each of the four audio monitoring connectors (numbered from
left to right on the backplane).
Value For each audio monitoring connector, the audio signal to be
monitored is specified by the video channel number and the
audio mono channel number.
Example: The value 'OUT1-01' for Mon #1 means that the
audio signal of the 1
st
audio mono channel of the PGM1 is sent
to the monitoring connector 1.
Default Values By default, the audio signal of the first play channel, and the
audio mono channels from 1 to 4 (OUT1-01 to OUT1-04) are
respectively assigned to the Mon #1 to Mon #4 connectors.
Overview on Advanced Audio Settings
Introduction
The Advanced Audio settings are defined from the Channels tab, pages 3 to 6 of the
Multicam Configuration window. These pages are only available in the advanced mode.
They allow audio channel routing, muting, and adjusting the audio gain.
The Advanced Audio settings for the inputs allow users to specify how the audio sources
are routed to the audio mono channels of each record channel.
The Advanced Audio settings for the outputs allow users to specify how the audio mono
channels are routed to each play channel (for embedded audio) or to the various physical
audio connectors (digital or analog connectors).
The table below shows in which page the advanced audio settings are available
depending on the audio type:
Page Type of audio settings
Page 3 audio inputs
Page 4 audio embedded outputs
Page 5 audio digital outputs (AES/EBU)
Page 6 audio analog outputs
Note
The settings for audio digital and analog outputs are only available when the
corresponding connectors are defined in the Audio connectors field that
reflects the audio hardware configuration.
XT3 Server-Version 11.00-Configuration Manual
3. Multicam Configuration 114
Comentarios a estos manuales