Evs XT3 Version 11.00 Configuration Manual Manual de usuario descargar pdf (Pagina 33)

2.3.7. Configuring Server Raids

Introduction

When the EVS server is started, the server raids are automatically detected, and built

based on the default settings described in the 'Default Raid Configuration' section below.

You can view the default raid configuration and modify it from the Raid Configuration

window. This window is only available in the server-based application.

Note

Only SAS drives from EVS can be used as they are specifically configured to

work with EVS video servers.

Overview on the Raid Configuration Window

The Raid Configuration window is available from the Multicam Setup window, when

pressing R to call the Raid Configuration command in the Tools menu:

The Requested Configuration area, in the upper part of the window, displays the default

raid configuration. You can modify the default raid configuration in this area. You will find

more information on editable parameters below.

The Current Configuration area, in the lower part of the Raid Configuration window,

provides raid and disk status information..

Default Raid Configuration

At the first start, the software builds the raids using the following settings:

• If internal and external storage are detected, both are used.

• (5+1) raid configuration with a maximum of 5 spares is used. First, all the raids are

built. The remaining disks are used as spare disks. The construction of raids starts

with internal arrays and carries on with external arrays. A raid can be created across

several hardware arrays.

27 2. Multicam Setup

EVS Broadcast Equipment S.A. -April 2012 Issue 11.00.C

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 226 227

Sin comentarios

Evs XT3 Version 11.00 Configuration Manual Manual de usuario Pagina 33