
10.05.D
XT33 Series DISK RECORDER – Version 10.05 - Software Technical Reference
EVS Broadcast Equipment SA – July 2011
VIDEO RECORDERS
Possible values in range: [1…6]
This parameter allows selecting the number of RECORD channels of the
application. The partition of the disk storage between these channels, and the
associated audio channels are automatically updated.
SLSM REC
This parameter defines the type of SLSM recorders. The parameter is only
editable if at least 2 channels are available to be used as SLSM recorders.
Otherwise, the parameter has the value “None” and is not editable.
Six types of record are available:
• None (Standard rate 50/60 Hz)
• Single SD SLSM 3x Alternate Parity – EVS mode (150/180 Hz)
• Single SD SLSM 3x Identical Parity (150/180 Hz)
• Single HD SLSM 2x Alternate Parity – EVS mode (100/120 Hz)
• Single HD SLSM 3x Alternate Parity – EVS mode
• Double HD SLSM 2x Alternate Parity – EVS mode
Note
The fault tolerance on the different phases of the super motion camera is
+/- 90% of one field. So there should be no delay between the different
phases when all equipments are genlocked.
AUDIO FORMAT
Possible values: [Analog (A), AES/EBU (D), Embedded (E), Dolby E AES (DY),
Dolby E Embedded (EY)]
This parameter allows selecting the Audio format.
When the Audio Format is set to AES/EBU (D or DY) or Embedded (E or EY), the
analogue audio outputs (if installed on the server) are automatically activated and
can be used for additional monitoring.
When the Audio Format is set to Embedded (E or EY), the digital audio (AES/EBU)
outputs (if installed on the server) are also active.
For more information on Dolby Audio Management, refer to section 1.4.5 ‘Dolby
Audio Management’, on page 23.
AUDIO TYPE
Possible values: [1 Track, 2 Tracks, 4 Tracks, 8 Tracks, 16 Tracks]
This parameter allows selecting the type of audio (number of mono audio tracks
associated to each video channel).
The following table specifies the audio types available for the various audio
formats:
Comentarios a estos manuales