EVS XT-3 Manual de usuario descargar pdf (Pagina 72)

Issue

10.05.D

XT33 Series DISK RECORDER – Version 10.05 - Software Technical Reference

EVS Broadcast Equipment SA – July 2011

2.4 INITIALIZING THE MICROCODE

The final step is the initialization of the microcode.

If the first line of the application is flashing with the message "Disk #x has been

disconnected in operation", the system will display the message: "Disk to be

disconnected: x". The system will work on 4 disks. Raid function is turned off.

The message "Init board: nb blocks of size kBytes. Audio:aud DiskUse:use%" is

displayed.

where

nb is the number of blocks used on the system

size is the size in kBytes of a block on a disk

aud is ON/OFF

use is the operationalDiskSize in %

If the system must load tables (no clear clips done in EVS main menu), the

message "Loading tables …" will appear.

When the initialization is complete, the system displays the message "H3X board

initialized" and the system is ready. If an error occurs, the message "ERROR

(0xErr): H3X board not correctly initialized" is displayed. The error (Err) are

detailed in the following section.

Possible Errors

If an error is detected while loading tables, the following message is displayed: "

LOAD <TAB>LE ERROR – state = [St]" where ‘St’ can be:

1. Block error A disk error occurred while loading the table on

hard disks. Maybe a disk failure. Replace disks.

2. Cache overflow

error

No more blocks available in cache. Algorithm

problem. Contact EVS.

3. Checksum error This can occur if a disk has been replaced and

data not rebuilt on it. Rebuild data on the disk to

clear the message. If no disk has been replaced,

try to re-

start the server to clear the error

message. If it does not resolve it after a few re-

start, a clear clip will be necessary.

4. Signature error The signature on the table file is not found in the

header file. Try to re-start the server to clear the

error message. If it does not resolve it after a few

re-start, a clear clip will be necessary.

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 93 94

Sin comentarios

EVS XT-3 Manual de usuario Pagina 72