EVS XT2+ Manual de usuario Pagina 41

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 85
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 40
XT2 Series DISK RECORDER - Version 10.05 - Software Technical Reference Manual
Issue
10.05.A
EVS Broadcast Equipment SA July 2011
33
NETWORK AREA
SDTI
Possible values: [off / 1485Mbps Non-Relay]
This parameter makes it possible to enable the SDTI option and select the
bandwidth of the network.
On XT2+ servers, there are one pair of SDTI connectors: XNet2 Non-Relay
connectors are used at 1485 Mbps.
The SDTI circuit is closed only when the Multicam software is started.
Important
The SDTI bandwidth must be identical on all XT2+ servers connected to
the XNet.
If one system is configured with a different bandwidth, it will block the
entire network.
The Disk Block Size parameter must be the same on all XT2+ servers.
Net Name
The Net name defines the machine name on the network. This name is user-
defined but cannot exceed 8 characters. Entering a Network Name is not
mandatory because a network number is also assigned to the system, but it is
recommended to easily identify all servers connected to the XNet.
Net Number
Range: [1 … 29]
The Net Number parameter defines the machine number on the network. This
number is user-defined and must be unique for each system on the network. When
entering a new number if this number is already assigned to another machine, an
error message will warn the user.
Type
Possible values: [Client, Master, Server]
The type defines the privileges of the XT2+ server on the SDTI network. One XT2+
server on the network should be set to Server type. If no server is defined, XNet
will not be activated. If more than one server is defined, only the first one to
connect will be the actual server.
Other XT2+ servers on the network can be set either to Master type if they need
to access clips from other servers, or to Client type if their clips must be available
on the network but they don’t need to access clips from other servers.
Vista de pagina 40
1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 84 85

Comentarios a estos manuales

Sin comentarios