EVS XT2+ Manual de usuario descargar pdf (Pagina 64)

Issue

10.05.A

XT2 Series DISK RECORDER – Version 10.05 - Software Technical Reference

EVS Broadcast Equipment SA – Jluly 2011

If the message "INIT ERROR: TIMED OUT – state = [St]" is displayed, it means

the initialization is not complete. ‘St’ refers to a position in the code.

Note:

Never forget that to start Multicam, the bootwins must successfully

initialize the microcode. In that case, the message "HCTX board

initialized" is displayed. In all other error case, the boot sequence or

initialization phase is cancelled and multicam cannot be started.

2.5 DISK DATA RECOVERY

When Multicam is started, it sometimes happens that the application does not

succeed in reading the data stored on the disks. However, the data is still

available on the disks.

The EVS Disk Doctor has been developed to address this issue. This tool allows

reconstructing the data (trains and clips) stored on the disks.

The tool scans each data block, identifies the recorder on which the data has been

created and reconstructs the whole audio and video material.

The clips will also be recovered. However several overlapping clips will be

recovered as one single long clip. This means that, in the schema below, the clips

CD, EF and GH will be recovered as one single long clip for which the IN point will

be C and the OUT point will be H.

If you want to use this tool, please contact the EVS support.

CAM A

A B

C D

Clip CD

E F

Cl i p EF

G H

Clip GH

Recovered clip

Recorded and recovered train

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 84 85

Sin comentarios

EVS XT2+ Manual de usuario Pagina 64