Evs XT3 MulticamLSM Version 11.01 - November 2012 Oper Manual de usuario Pagina 164

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 209
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 163
Multicam - Version 11.01 Operating Manual
EVS Broadcast Equipment SA November 2012
154
13.4.2 How to Name a Remote Clip
To name a remote clip, proceed as follows:
1. Select the Clip mode in the Network menu.
2. Select the Remote LSM in the list.
3. Go to the Clip screen on the VGA, all banks of remote system are now displayed.
4. Select the clip to name.
5. Type the desired name on the keyboard.
6. Press F1 to name the remote clip.
In CAM mode, only the camera where the cursor is located is named
In CLIP mode, all cameras of the clip where the cursor is located are named.
Note
To be able to rename a clip on a remote server, the Clip Edit by Network
parameter must be enabled in the Setup menu.
13.4.3 How to Modify IN/OUT Points of a Remote
Clip
To modify IN/OUT points of a remote clip, proceed as follows:
1. Recall the desired clip.
2. Browse inside the clip until you reach the desired frame.
3. Press IN / OUT to mark a new Short IN / Short OUT points.
Note
To be able to trim a clip on a remote server, the Clip Edit by Network
parameter must be enabled in the Setup menu of the remote machine.
Vista de pagina 163
1 2 ... 159 160 161 162 163 164 165 166 167 168 169 ... 208 209

Comentarios a estos manuales

Sin comentarios