Evs XT3 MulticamLSM Version 11.01 - November 2012 Oper Manual de usuario Pagina 191

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 209
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 190
Multicam - Version 11.01 Operating Manual
EVS Broadcast Equipment SA November 2012
Issue
11.01.D
181
18.3 Controlling the Hypermotion Camera
from the Remote
18.3.1 Introduction
This section presents the various commands you can use on the remote panel to control
the hypermotion camera. The corresponding command on the hypermotion camera is
mentioned when available.
The standard behavior, applicable to all cameras (Photron, Vision Research and NAC) is
first explained. When a given camera has a specific behavior, this is explicitly mentioned.
18.3.2 The Remote Keys
PLAY
This key corresponds to the ‘Play’ command on hypermotion cameras.
Press the PLAY key on the remote to initiate a replay on the current memory block.
The corresponding CAM key flashes green to indicate the playback status.
Note
The PLAY button behavior depends on the camera model.
SHIFT+PLAY
There is no corresponding command on hypermotion cameras.
Press the SHIFT+PLAY keys on the remote to initiate a replay on the current memory
block at the speed defined in the PGMSpeed parameter.
Press again PLAY, SHIFT+PLAY, or PRV CTL to return to the normal playing speed.
The corresponding CAM key flashes green to indicate the playback status.
Mark
This key corresponds to the ‘Mark Cue Point’ command on hypermotion cameras.
With a single-block memory, press Mark to mark a cue point on the current block. You
can mark up to 255 cue points on a memory block.
This function is not available on all cameras with multiple-block memory.
Vista de pagina 190
1 2 ... 186 187 188 189 190 191 192 193 194 195 196 ... 208 209

Comentarios a estos manuales

Sin comentarios