
Multicam - Version 11.01 – Operating Manual
EVS Broadcast Equipment SA – November 2012
18.2 Menus
18.2.1 Accessing and Leaving the Hypermotion
Mode
To access the hypermotion menu, press SHIFT+D (HyperMo) in your Remote perational
menu.
To leave the hypermotion menu or switch to the PGM control, press again SHIFT+D in
the operational menu.
Note
In hypermotion+LSM mode, the D’ key displays LSM Mode.
18.2.2 Hypermotion Main Menu
The hypermotion main menu displays the memory blocks that have been selected in the
# Blocks parameter of the hypermotion secondary menu. The memory blocks use is
described later in this chapter.
Only the activated blocks will be displayed and the highlighted block is the one the
operator is currently working on.
The Cues Parameter
The default value of the Cues parameter is On.
The Last Cue Parameter
The Last Cue parameter defines the Last Cue button function when the Cues value is
Off.
• The Last Cue parameter can be set to Ramp Up (the default value):
o The first time the Last Cue button is pressed, the speed is increased starting
from the PGMSpeed until the maximum speed is reached. This maximum speed
depends on the camera model.
Comentarios a estos manuales