Evs XT3 MulticamLSM Version 11.01 - November 2012 Oper Manual de usuario Pagina 200

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 209
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 199
Multicam - Version 11.01 Operating Manual
EVS Broadcast Equipment SA November 2012
190
18.5.2 NAC Camera Hi-Motion II
Application Start
At application start, this camera is in ARM mode and the recording starts on the first
memory block.
Configuration Parameter Values
Port = RS422
Protocol = Sony 9-PIN
The PGMSpeed parameter value 1000 is available.
Last Cue values (when Cues is Off): 50, 100, 200, 300, 400, 600, 1200, 1600
Key Behavior
PLAY: this key initiates a replay on the current memory block. The replay position
can be set on the camera (beginning, end, specific position in the block).
TAKE: this key is operational in ARM mode. In loop mode, once the last block is
used, the recording starts again on the first block.
RECORD: the remote beeps if the CAM key refers to an empty block.
RECORD: pressing this key while the current block is recording does not send any
command to the camera.
ENTER: press this key together with a CAM key to lock the corresponding memory
block.
o If the corresponding block is empty, the remote beeps.
o You cannot lock a recording block.
Last Cue: If no cue points have been defined, pressing this key will stop the
recording and go back to the first recorded frame of the current memory block.
CAM keys:
o Selecting a block for the first time loads the block at the frame specified in the
camera menu. You can then brwse through it or play it.
o Selecting the same block another time loads it at the frame it was last loaded on.
Cue points management
Cue points are only managed in Loop mode.
When a new ARM/REC command is issued on a block, all its cue points are cleared.
If the Last Cue command cannot access the desired TC-pre-roll, the player remains
on the current cue point.
Vista de pagina 199
1 2 ... 195 196 197 198 199 200 201 202 203 204 205 ... 208 209

Comentarios a estos manuales

Sin comentarios