Evs XT3 MulticamLSM Version 11.01 - November 2012 Oper Manual de usuario descargar pdf (Pagina 39)

Multicam - Version 11.01 – Operating Manual

EVS Broadcast Equipment SA – November 2012

Issue

11.01.D

When the user exits Multicam with the Post-Roll mode on, this mode will still be enabled

when Multicam is restarted.

The Post-Roll mode works as follows depending on the element played:

• When a clip is played, it will not stop on the Short OUT point, but will continue to play

through the Short OUT point by the Post-Roll duration defined in the Setup Menu.

• When a record train is played, the same will happen if the Record trains OUTs

parameter is set to “Freeze” in the Operational Setup menu (p.2.3 F1).

• When a playlist is played, the Post-Roll will apply only to the last clip of the playlist.

Sort->TC

This function allows the operator to search for all clips that contain a particular timecode.

For more information on this function, refer to the section ‘Sort->TC’, on page 49.

This function allows the operator to search the database using keywords and ranking.

Refer to the chapter 10 “Keyword Management” on page 72 for further details.

To return to the operational menu, press the MENU key from the Remote Panel.

6.1.2 Operational Menu

Rst Cam

Local

Sync Prv

2nd CTRL

Cam A

Cam B

Cam C

Cam D

CAM A/ B /C /D

If PRV CTL is OFF, select the camera to assign to the PGM output. This camera key will

be highlighted in the menu.

If PRV CTL is ON, select the camera to assign to the PRV output. This camera key will

be highlighted in the menu.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 208 209

Sin comentarios

Evs XT3 MulticamLSM Version 11.01 - November 2012 Oper Manual de usuario Pagina 39