Evs XT3 MulticamLSM Version 11.01 - November 2012 Oper Manual de usuario descargar pdf (Pagina 202)

Issue

11.01.D

Multicam - Version 11.01 – Operating Manual

EVS Broadcast Equipment SA – November 2012

192

Cue points management

• When a new ARM/REC command is issued on a block, all its cue points are cleared.

• If the Last Cue command cannot access the desired TC-pre-roll, the player remains

on the current cue point.

• If the Last Cue command refers to a TC that does not exist anymore, the player

jumps to the beginning of the current memory block.

• Cue points can not be marked when working on several memory blocks.

18.5.4 Vision Research Camera

Application Start

At application start, the recording does not start automatically.

Configuration Parameter Values

• Port = RS422 & Protocol = ASCII

• Or Port = Ethernet & Protocol = TCP

• The PGMSpeed parameter value 1000 is available.

• Last Cue values (when Cues is Off): 50, 100, 200, 300, 400, 600, 800, 1000

Key Behavior

• PLAY: this key initiates a replay from the first available frame on the current memory

block.

• TAKE: this key is operational in any mode.

• RECORD: the remote beeps if the CAM key refers to an empty block.

• RECORD: pressing this key while the current block is recording clears all memory

blocks and starts recording on the first one.

• CLEAR: press this key to delete the current memory block data.

• Last Cue: If no cue points have been defined, pressing this key will stop the

recording and go back to the first recorded frame of the current memory block.

Cue points management

• When a new ARM/REC command is issued on a block, all its cue points are cleared.

• If the Last Cue command cannot access the desired TC-pre-roll, the player remains

on the current cue point.

1 2 ... 197 198 199 200 201 202 203 204 205 206 207 208 209

Sin comentarios

Evs XT3 MulticamLSM Version 11.01 - November 2012 Oper Manual de usuario Pagina 202