Evs MulticamLSM Version 11.00 Operating Manual Manual de usuario Pagina 160

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 199
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 159
Issue
11.00.C
EVS Broadcast Equipment SA April 2012
150
13.4.2 How to Name a Remote Clip
To name a remote clip, proceed as follows:
1. Select the Clip mode in the Network menu.
2. Select the Remote LSM in the list.
3. Go to the Clip screen on the VGA, all banks of remote system are now displayed.
4. Select the clip to name.
5. Type the desired name on the keyboard.
6. Press F1 to name the remote clip.
In CAM mode, only the camera where the cursor is located is named
In CLIP mode, all cameras of the clip where the cursor is located are named.
Note
To be able to rename a clip on a remote server, the Clip Edit by Network
parameter must be enabled in the Setup menu.
13.4.3 How to Modify IN/OUT Points of a Remote Clip
To modify IN/OUT points of a remote clip, proceed as follows:
1. Recall the desired clip.
2. Browse inside the clip until you reach the desired frame.
3. Press IN / OUT to mark a new Short IN / Short OUT points.
Note
To be able to trim a clip on a remote server, the Clip Edit by Network
parameter must be enabled in the Setup menu of the remote machine.
Vista de pagina 159
1 2 ... 155 156 157 158 159 160 161 162 163 164 165 ... 198 199

Comentarios a estos manuales

Sin comentarios