Evs MulticamLSM Version 11.00 Operating Manual Manual de usuario descargar pdf (Pagina 170)

Issue

11.00.C

Multicam - Version 11.00 – Operating Manual

EVS Broadcast Equipment SA – April 2012

160

15.2.3 How to Highlight Video Material

To highlight video material, proceed as follows:

1. Select the material that you wish to highlight (this may be a clip, or simply a cued

replay).

2. Position the material on the field corresponding to the target start point and place the

pen on the tablet.

At this point the tracking object will appear on the screen. If the tracking object is an

arrow, it will appear slightly off the cursor position, so that the object remains visible.

3. When the circle is positioned correctly, mark a keyframe:

o by pressing the button of the stylus,

o by clicking on the M sign on the monitoring screen

The K will now appear in the upper left corner indicating that a keyframe has been

marked.

4. Re-position the material, and mark the next keyframe, and so on...

When the final keyframe has been marked, the replay can be re-cued.

When the replay is animated, the illustration will appear with a dissolve effect at the first

keyframe and disappear, with a dissolve effect, at the last.

Run through the material in Loop mode and the effect can now be retrieved and stored as

a new clip with the target tracking.

This can be repeated several times to include multiple circles. Refer to the ‘Loop’

explanation on page 18.

15.2.4 Rules When Using Keyframes

1. The first / last keyframes can be at the IN / OUT points of the clip.

2. If, when a replay is viewed, the action is not accurately followed, stop the replay

where the tracking object has drifted away from the target and use the pen to move

the circle to the correct point, marking an additional keyframe. This can be done as

many times as necessary.

3. When checking / modifying a track, the arrows that appear at the bottom left of the

screen may be used to select the next/previous marked keyframe.

4. If one keyframe is to be erased, use the arrows to get to the appropriate keyframe

and then select ERASE (E). Erasing ALL keyframes can be done using RESET (R).

5. If working in network mode, target tracking can be performed on remote clips as well

as local clips.

1 2 ... 165 166 167 168 169 170 171 172 173 174 175 ... 198 199

Sin comentarios

Evs MulticamLSM Version 11.00 Operating Manual Manual de usuario Pagina 170