Evs MulticamLSM Version 11.00 Operating Manual Manual de usuario descargar pdf (Pagina 70)

Issue

11.00.C

Multicam - Version 11.00 – Operating Manual

EVS Broadcast Equipment SA – April 2012

9.3.12 How to Restripe the Timecode of the Current Clip

To restripe the timecode of the current clip, proceed as follows:

1. Recall the clip by moving the cursor on the desired clip and pressing ENTER, or by

clicking on it with the stylus.

2. Press ALT-T on the keyboard to call the SET TC function.

The Set Timecode screen is displayed (without TC Type field with PAL – refer to note

below):

3. If you want to modify the LTC timecode and date, type in the new timecode for the

Short IN point and date of the clip in the Set TC field below the LTC field.

4. If you want to modify the user-defined timecode and date, type in the new timecode

for the Short IN point and date of the clip in the Set TC field below the USER field.

5. If you want to modify the primary TC for this clip, press the A or B key which

corresponds to the requested primary TC.

6. Press F2 to select CAM or CLIP mode

• In CAM mode, only the timecode of the camera angle loaded on the primary

channel will be changed.

• In CLIP mode, the timecode of all camera angles of the clip will be changed.

7. Press ENTER to confirm or ESC to cancel.

The entire clip is updated according to the new timecode value so that the timecode

remains continuous inside the whole clip.

Note

In 59.94Hz modes (NTSC), you can also select between DROP FRAME and

NON DROP FRAME modes by pressing the space bar.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 198 199

Sin comentarios

Evs MulticamLSM Version 11.00 Operating Manual Manual de usuario Pagina 70