Evs MulticamLSM Version 11.00 Operating Manual Manual de usuario descargar pdf (Pagina 60)

Issue

11.00.C

Multicam - Version 11.00 – Operating Manual

EVS Broadcast Equipment SA – April 2012

primary timecode of the clip.

• You cannot modify the date of the clip.

• You cannot modify the type for the primary timecode of the clip.

If you want to modify the date, the type of the primary timecode or the user-defined

timecode, you need to go to the Set Timecode screen in the VGA. For more information,

refer to the section 9.3.12 ‘How to Restripe the Timecode of the Current Clip’, on page

60.

How to Restripe the Timecode of a Clip

To restripe the timecode of a clip on the Remote Panel, proceed as follows:

1. Recall the clip by pressing the corresponding F_ key.

2. Move the jog dial to reach the picture where you want to define a new timecode.

3. Press the MENU key to access the secondary menu.

4. Press SHIFT+C to call the Set TC function.

5. Enter the new timecode for the current picture.

6. In 59.94 Hz modes (NTSC), you can select between Drop Frame and Non Drop

Frame modes by pressing SHIFT+MENU.

7. Press the D key to select CAM or CLIP mode.

• In CAM mode, only the timecode of the camera angle loaded on the primary

channel will be changed.

• In CLIP mode, the timecode of all camera angles of the clip will be changed.

8. Press ENTER to confirm or MENU to cancel.

The primary timecode of the entire clip is updated according to the new timecode value

so that the timecode remains continuous inside the whole clip. Next time this function is

called, the value previously used will be set as default.

9.3 Using the Clip screen

The VGA Clip screen is accessed by selecting the F9 key on the keyboard. With this

screen, clips can be recalled using the pen and tablet or directly from the keyboard.

Important

The action performed on a channel from the Clip screen is concurrent to any

other controller that might be assigned to that channel: EVS Remote Panel or

external protocol. A command sent from the Clip screen to a channel will

overwrite whatever the channel was doing at that time.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 198 199

Sin comentarios

Evs MulticamLSM Version 11.00 Operating Manual Manual de usuario Pagina 60